[. . . ] music hall mpp INSTRUCTION MANUAL music hall http://www. musichallaudio. com In the past, all audio system control components (integrated amplifiers, receivers and system pre-amplifiers) had phono inputs. [. . . ] The Phono Box is configured for MM cartridges at the factory, so if a MM or high output MC cartridge is being used no changes to the settings are required. MM setting: this setting should be used with ALL moving magnet cartridges and any high output moving coil cartridge with a voltage output of 1. 5 mV or HIGHER. Please consult your cartridge manual, looking on the specification page for the output voltage, or dealer for this information. MC setting: this setting should be used with all low output moving coil cartridges (voltage output lower than 1. 5 mV). Again, please consult your cartridge manual, looking on the specification page for the output voltage, or dealer for this information. 1. Remove the four screws on the side of The Phono Box and remove the top cover. Adjust the jumpers to match your cartridge as indicated in the diagrams above. With the Phono Box properly configured for the cartridge in use it can be installed into the system, following the instructions on the next page. 1. Connect the interconnect cables from the turntable to the left and right inputs of The Phono Box, and attach the ground wire to the terminal between the pairs of input and output jacks. [. . . ] FOR FURTHER INFORMATION CONTACT: music hall 108 Station Road Great Neck, NY 11023 Tel: 516-487-3663 Fax: 516-773-3891 http://www. musichallaudio. com [. . . ]